Kaynağa Gözat
Giving more breathing room for regular keys to be enable initially.
- Should be tested more on keyboards without test points (to see if more of a margin in necessary) - Added more information messages on bootupsimple
Jacob Alexander
10 yıl önce
1 değiştirilmiş dosya ile 10 ekleme ve 1 silme
+ 10
- 1
Scan/DPH/scan_loop.c
Dosyayı Görüntüle
| @@ -213,6 +213,8 @@ inline void Scan_setup() | |||
| // This means, the strobe GPIO can be set to Tri-State pull-up to detect which strobe lines are not used. | |||
| // NOTE2: This will *NOT* detect floating strobes. | |||
| // NOTE3: Rev 0.4, the strobe numbers are reversed, so D0 is actually strobe 0 and C7 is strobe 17 | |||
| info_msg("Detecting Strobes..."); | |||
| DDRC = 0; | |||
| PORTC = C_MASK; | |||
| DDRD = 0; | |||
| @@ -278,6 +280,9 @@ inline void Scan_setup() | |||
| } | |||
| } | |||
| printInt8( total_strobes ); | |||
| print( " strobes found." NL ); | |||
| // Setup Pins for Strobing | |||
| DDRC = C_MASK; | |||
| PORTC = 0; | |||
| @@ -398,7 +403,8 @@ inline void capsense_scan() | |||
| } | |||
| // If sample is higher than previous high_avg, then mark as "problem key" | |||
| keys_problem[strobe_line + mux] = sample > high_avg ? sample : 0; | |||
| // XXX Giving a bit more margin to pass (high_avg vs. high_avg + high_avg - full_avg) -HaaTa | |||
| keys_problem[strobe_line + mux] = sample > high_avg + (high_avg - full_avg) ? sample : 0; | |||
| // Prepare for next average | |||
| cur_full_avg += sample; | |||
| @@ -462,6 +468,9 @@ inline void capsense_scan() | |||
| printInt8( low_count ); | |||
| print("): "); | |||
| printHex( low_avg ); | |||
| print(" Rejection threshold: "); | |||
| printHex( high_avg + (high_avg - full_avg) ); | |||
| print( NL ); | |||
| // Display problem keys, and the sense value at the time | |||