a25aa84513
- Basic support for up to 4 ISSI chips (and partial support for 16 chip configurations) - Initial USB mux support * Required USB re-init procedure - Initial interconnect mux support * Required some state reset commands
49 lines
1.7 KiB
Plaintext
49 lines
1.7 KiB
Plaintext
Name = UARTConnectCapabilities;
|
|
Version = 0.1;
|
|
Author = "HaaTa (Jacob Alexander) 2015";
|
|
KLL = 0.3a;
|
|
|
|
# Modified Date
|
|
Date = 2015-03-15;
|
|
|
|
# UART Buffer Size
|
|
# Number of bytes to reserve for each side of UARTConnect
|
|
# For true NKRO support must be at least: <# of Keys> x 3 + 5
|
|
UARTConnectBufSize => UARTConnectBufSize_define;
|
|
UARTConnectBufSize = 128; # MDErgo1 requires at least a 119 byte buffer
|
|
|
|
# UART Speed
|
|
# *NOTE* This must be changed on every device in the chain or else UARTConnect will not work
|
|
# The faster the speed, the lower the latency, but higher chance for an error
|
|
UARTConnectBaud => UARTConnectBaud_define;
|
|
UARTConnectBaudFine => UARTConnectBaudFine_define;
|
|
# Generally, leave BaudFine at zero unless trying to tune the link to an external UART
|
|
# You'll want to look at the specific chip datasheet for the exact equation
|
|
#
|
|
# Example of 115200 Baud using a 48 MHz clock (mk20dx128vlf5)
|
|
# 48 MHz / ( 16 * Baud ) = BDH/L
|
|
# Baud: 115200 -> 48 MHz / ( 16 * 115200 ) = 26.0416667
|
|
# Thus baud setting = 26
|
|
# NOTE: If finer baud adjustment is needed see UARTx_C4 -> BRFA in the datasheet
|
|
# Baud fine setting = 0x02
|
|
UARTConnectBaud = 1; # 4.5 Mbps @ 72 MHz
|
|
UARTConnectBaudFine = 0x0;
|
|
|
|
#UARTConnectBaud = 39; # 115385 bps @ 72 MHz (close to 115200)
|
|
|
|
# Cable Check Command Length
|
|
# This defines the length of the cable command
|
|
# 0xD2 11010010 is used for each check byte
|
|
#
|
|
# For example:
|
|
# Length: 4
|
|
# Args: 0xD2 0xD2 0xD2 0xD2
|
|
UARTConnectCableCheckLength => UARTConnectCableCheckLength_define;
|
|
UARTConnectCableCheckLength = 2;
|
|
|
|
# Connect Enable
|
|
# Define used to indicate to non-connect modules that support should be compiled in
|
|
ConnectEnabled => ConnectEnabled_define;
|
|
ConnectEnabled = 1;
|
|
|