Archived
1
0
This repo is archived. You can view files and clone it, but cannot push or open issues or pull requests.
keybrd/unit_tests/PortWrite_MCP23S17/PortRead_MCP23S17.ino
2016-09-02 20:24:55 -06:00

36 lines
1020 B
C++

/* unit test for PortRead_MCP23S17
The setup is an MCP23S17 I/O expander on a Teensy LC controller.
MCP23S17 port-A GPIO pins are not connected to anything.
Port-A GPIO-pin ouputs alternate between 0 and 3.3 volts.
Use a volt meter to measure port-A GPIO-pin ouputs.
MCP23S17 on 3.3v does not output enough power to reliable light LEDs
LED lights w/o resistor
LED not light with 56 ohm resistor
*/
#include "PortIOE.h"
#include "PortWrite_MCP23S17.h"
const uint8_t PortIOE::ADDR = 0x20; //MCP23S17 address, all 3 ADDR pins are grounded
PortIOE portA(0, 0);
PortWrite_MCP23S17 portAWrite(portA); //PortAWrite needed for begin()
const uint8_t GPIOA = 0x12; //LEDs are on port A
void setup()
{
delay(6000);
portAWrite.begin();
//Keyboard.print("start blinking");
}
void loop()
{
portAWrite.write(~0, HIGH); //set all GPIOA pins HIGH
delay(2000);
portAWrite.write(~0, LOW); //set all GPIOA pins LOW
delay(2000);
}