#include "Port_MCP23018.h"

/* beginProtocol() is called from Scanner_IOE::begin().  Initiates I2C bus.

MCP23018 supports I2C SCL Clock Frequencies: 100 kHz, 400 kHz, 1000 kHz (Datasheet page 1 & 6)
The electrical limitation to bus speed is bus capacitance and the length of the wires involved.
Longer wires require lower clock speeds.
 http://playground.arduino.cc/Main/WireLibraryDetailedReference > Wire.setclock()
*/
void Port_MCP23018::beginProtocol()
{
    Wire.begin();                               //initiate I2C bus to 100 kHz
}

/* begin() is called from Scanner_IOE::begin().
Configures port's IODIR and GPPU.
*/
void Port_MCP23018::begin(const uint8_t strobeOn)
{
    uint8_t pullUp;                             //bits, GPPU 0=pull-up disabled, 1=pull-up enabled

    if (strobeOn == LOW)                        //if active low
    {
        pullUp = readPins;              //0=pull-up disabled (for LED), 1=pull-up enabled (for read)
    }
    else                                        //if active high
    {
        pullUp = 0;                         //0=pull-up disabled (for external pull-down resistors)
    }

    Wire.beginTransmission(deviceAddr);
    Wire.write(portNum);                        //IODIR
    Wire.write(readPins);                       //0=output (for strobe and LED), 1=input (for read)
    Wire.endTransmission();

    Wire.beginTransmission(deviceAddr);
    Wire.write(portNum + 0x0C);                 //GPPU
    Wire.write(pullUp);
    Wire.endTransmission();
}

/* write() sets pin output to logicLevel.
pin is bit pattern, where pin being strobed is 1.
logicLevel is HIGH or LOW.
write() does not overwrite the other pins.
*/
void Port_MCP23018::write(const uint8_t pin, const bool logicLevel)
{
    if (logicLevel == LOW)
    {
        outputVal &= ~pin;                      //set pin output to low
    }
    else
    {
        outputVal |= pin;                       //set pin output to high
    }

    Wire.beginTransmission(deviceAddr);
    Wire.write(portNum + 0x12);                 //GPIO
    Wire.write(outputVal);
    Wire.endTransmission();
}

/* read() returns portState.
Only portState bits of readPins are valid.
*/
uint8_t Port_MCP23018::read()
{
    Wire.beginTransmission(deviceAddr);
    Wire.write(portNum + 0x12);                 //GPIO
    Wire.endTransmission(false);                //MCP23018 needs false to send a restart ??really?

    Wire.requestFrom(deviceAddr, 1u);           //request one byte from input port

    return Wire.read();
}