- Each scan module now has a current change callback which passes the available current as a parameter
- No longer attempts to use the max 500 mA immediately, starts with 100 mA then goes to 500 mA after enumeration
- If enumeration fails due to bMaxPower of 500 mA, then attempt again at 100 mA (might also be possible to go even lower to 20 mA in certain cases)
- Now working with the Apple Ipad (no over-power messages)
- Fixed Wake-up behaviour on Apple Ipad (and likely other iOS devices)
- More effecient set_feature/clear_feature handling (device handler)
- Initial power handling via Interconnect (still needs work to get it more dynamic)
- Added port swapping to KType
- Added initial KType default keymappings
- Initial PixelMap animiation framework
- Swapped in new i2c library for ISSILed
- Basic support for up to 4 ISSI chips (and partial support for 16 chip configurations)
- Initial USB mux support
* Required USB re-init procedure
- Initial interconnect mux support
* Required some state reset commands
- Works for all nodes in chain
- Synchronized to 30 ms update rate (required for ISSI chip)
* Interconnect cannot handle full update speed from Scan module
* Though it should be able to handle quite a bit more than 30 ms updates
- 6 modes
* Single led: decrease, increase, set
* All leds: decrease, increase, set
- Currently update speed limited to once every 30 ms
* Likely an I2C driver or ISSI limitation preventing even faster updates
