1
0
tmk_keyboard/converter/ps2_usb/Makefile

117 lines
3.4 KiB
Makefile
Raw Normal View History

2011-01-17 12:51:51 +00:00
# Target file name (without extension).
2016-09-17 01:20:52 +00:00
TARGET ?= ps2_usb
2011-01-17 12:51:51 +00:00
# Directory common source filess exist
2016-09-17 01:20:52 +00:00
TMK_DIR ?= ../../tmk_core
2011-01-17 12:51:51 +00:00
# Directory keyboard dependent files exist
2016-09-17 01:20:52 +00:00
TARGET_DIR ?= .
2011-01-17 12:51:51 +00:00
# project specific files
2016-09-17 01:20:52 +00:00
SRC ?= matrix.c \
led.c
2016-09-17 01:20:52 +00:00
#
# Keymap file
#
ifdef UNIMAP_ENABLE
KEYMAP_FILE = unimap
else
ifdef ACTIONMAP_ENABLE
KEYMAP_FILE = actionmap
else
KEYMAP_FILE = keymap
endif
endif
ifdef KEYMAP
2016-09-17 01:20:52 +00:00
SRC := $(KEYMAP_FILE)_$(KEYMAP).c $(SRC)
else
2016-09-17 01:20:52 +00:00
SRC := $(KEYMAP_FILE)_plain.c $(SRC)
endif
2016-09-17 01:20:52 +00:00
CONFIG_H ?= config.h
2011-01-17 12:51:51 +00:00
# MCU name
2016-09-17 01:20:52 +00:00
MCU ?= atmega32u2
2011-01-17 12:51:51 +00:00
# Processor frequency.
# This will define a symbol, F_CPU, in all source code files equal to the
# processor frequency in Hz. You can then use this symbol in your source code to
# calculate timings. Do NOT tack on a 'UL' at the end, this will be done
# automatically to create a 32-bit value in your source code.
#
# This will be an integer division of F_USB below, as it is sourced by
# F_USB after it has run through any CPU prescalers. Note that this value
# does not *change* the processor frequency - it should merely be updated to
# reflect the processor speed set externally so that the code can use accurate
# software delays.
2016-09-17 01:20:52 +00:00
F_CPU ?= 16000000
2011-01-17 12:51:51 +00:00
#
# LUFA specific
#
# Target architecture (see library "Board Types" documentation).
2016-09-17 01:20:52 +00:00
ARCH ?= AVR8
# Input clock frequency.
# This will define a symbol, F_USB, in all source code files equal to the
# input clock frequency (before any prescaling is performed) in Hz. This value may
# differ from F_CPU if prescaling is used on the latter, and is required as the
# raw input clock is fed directly to the PLL sections of the AVR for high speed
# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
# at the end, this will be done automatically to create a 32-bit value in your
# source code.
#
# If no clock division is performed on the input clock inside the AVR (via the
# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
2016-09-17 01:20:52 +00:00
F_USB ?= $(F_CPU)
2011-01-17 12:51:51 +00:00
2016-10-04 07:05:51 +00:00
# Interrupt driven control endpoint task
# Not work with suart debug
2014-04-29 10:42:24 +00:00
#OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
2012-10-14 11:03:26 +00:00
2016-10-04 07:05:51 +00:00
# This improves response of keyboard when wakeup
OPT_DEFS += -DSUSPEND_MODE_STANDBY
2012-10-14 11:03:26 +00:00
# Boot Section Size in *bytes*
# Teensy halfKay 512
# Teensy++ halfKay 1024
# Atmel DFU loader 4096
# LUFA bootloader 4096
# USBaspLoader 2048
2016-09-17 01:20:52 +00:00
BOOTLOADER_SIZE ?= 4096
OPT_DEFS += -DBOOTLOADER_SIZE=$(BOOTLOADER_SIZE)
2012-10-14 11:03:26 +00:00
# Build Options
# comment out to disable the options.
#
2016-09-17 01:20:52 +00:00
BOOTMAGIC_ENABLE ?= no # Virtual DIP switch configuration(+1000)
MOUSEKEY_ENABLE ?= no # Mouse keys(+4700)
EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450)
CONSOLE_ENABLE ?= yes # Console for debug(+400)
COMMAND_ENABLE ?= yes # Commands for debug and configuration
NKRO_ENABLE ?= yes # USB Nkey Rollover - not yet supported in LUFA
2012-10-14 11:03:26 +00:00
2011-01-17 12:51:51 +00:00
# PS/2 Options
#
2016-09-17 01:20:52 +00:00
#PS2_USE_USART ?= yes # uses hardware USART engine for PS/2 signal receive(recomened)
PS2_USE_INT ?= yes # uses external interrupt for falling edge of PS/2 clock pin
#PS2_USE_BUSYWAIT ?= yes # uses primitive reference code
2011-02-21 06:43:17 +00:00
# Optimize size but this may cause error "relocation truncated to fit"
#EXTRALDFLAGS = -Wl,--relax
2011-02-21 06:43:17 +00:00
2012-06-30 05:44:59 +00:00
# Search Path
VPATH += $(TARGET_DIR)
2015-04-09 07:20:42 +00:00
VPATH += $(TMK_DIR)
2012-06-30 05:44:59 +00:00
2015-04-09 07:20:42 +00:00
include $(TMK_DIR)/protocol.mk
include $(TMK_DIR)/protocol/lufa.mk
include $(TMK_DIR)/common.mk
include $(TMK_DIR)/rules.mk