- Added fix for USB Current Change
  * If called during interrupt, could hang the I2C bus
  * Delaying I2C writes till scan loop

- Each scan module now has a current change callback which passes the available current as a parameter
- No longer attempts to use the max 500 mA immediately, starts with 100 mA then goes to 500 mA after enumeration
- If enumeration fails due to bMaxPower of 500 mA, then attempt again at 100 mA (might also be possible to go even lower to 20 mA in certain cases)
- Now working with the Apple Ipad (no over-power messages)
- Fixed Wake-up behaviour on Apple Ipad (and likely other iOS devices)
- More effecient set_feature/clear_feature handling (device handler)
- Initial power handling via Interconnect (still needs work to get it more dynamic)

- Works for all nodes in chain
- Synchronized to 30 ms update rate (required for ISSI chip)
  * Interconnect cannot handle full update speed from Scan module
  * Though it should be able to handle quite a bit more than 30 ms updates

- 6 modes
  * Single led: decrease, increase, set
  * All leds: decrease, increase, set
- Currently update speed limited to once every 30 ms
  * Likely an I2C driver or ISSI limitation preventing even faster updates

- Adds override functionality in main module

- Changing header file ifndef define to pragma once's
- Removed duplicate output_com.h's

- Basic screen initialization and clear is working
- Currently SPI is set to a low speed for easy logic analyzer debugging

- Not ready for advanced support yet
- Basic register and page writing support complete