- Works for all nodes in chain
- Synchronized to 30 ms update rate (required for ISSI chip)
* Interconnect cannot handle full update speed from Scan module
* Though it should be able to handle quite a bit more than 30 ms updates
- Rx buffers weren't fast enough, had to use DMA :D
- Basic LCD remote capabilities are working, single node
- Multi-node broadcast seems to have a bug still
- DMA ring buffer allowed for significant processing simplification
* There is an overrun risk, but the buffer is large and generally there isn't too much data being sent (just very quickly)
- Split out LCD layer stack capability into itself and an "exact" version used for updating remote nodes
- 6 modes
* Single led: decrease, increase, set
* All leds: decrease, increase, set
- Currently update speed limited to once every 30 ms
* Likely an I2C driver or ISSI limitation preventing even faster updates
- Implementation was completely wrong (has never worked properly)
- Now working in both NKRO and 6KRO modes
- Added more debugging code if things go wrong again
- Adds proper flashMode support for all keyboards and microcontrollers (usb and serial)
- flashModeEnabled must be set to 1 otherwise it will only show an error
* This is on purpose (somewhat dangerous feature as it allows remote flashing)
- Capability cleanup
- Media keys tested working on Linux/Windows/Mac (use Consumer control)
- Fixed enumeration delays
- Fixed virtual serial port configuration issues
- Fixed GET_REPORT and SET_REPORT
- Added intial descriptors and endpoints for Mouse and Joystick devices
- Split out the consumer and system control endpoint
- Added more fault debugging messages
- Added interface names to endpoints (visible in Windows Device Manager)
- Added KLL define for keyboard locale
- Supports up to 255 slave nodes (you'll run into ScanCode limitations before then)
- Requires most recent kll compiler update
- Additional debugging output and stats counters
- Noise and parity checking
- Fixed TxFIFO issue when sending buffers larger than the FIFO
- Cleaned up defaultMap.kll
- Added ScanCode caching (reduces interconnect traffic significantly)
- Interconnect module code is conditionally compiled into PartialMap module if required
- Still some issues
- Will require some changes to MatrixARM and PartialMap
* Currently state information is passed around too frequently
* Needs to be reduced to state changes only
- Uses expiry timer to decide on when to allow a state change
- Initial state transitions are unaffected
- Use MinDebounceTime define in kll to configure
- ms granularity
